Search found 7 matches

by mishafarms
Thu Dec 26, 2019 11:00 pm
Forum: ESP32 IDF
Topic: Add non-cmake source library to project build?
Replies: 4
Views: 451

Re: Add non-cmake source library to project build?

UPDATE. My issue was not having the following line idf_component_register() everything is working now. Except that I want to have a new target call it flashfatfs. I want to build this when I want to. For a Makefile project I just added the target and I could type "make flashfatfs" and make would run...
by mishafarms
Sun Dec 22, 2019 5:45 pm
Forum: ESP32 IDF
Topic: Add non-cmake source library to project build?
Replies: 4
Views: 451

Re: Add non-cmake source library to project build?

I tried to use the ExternalProject_Add, but I am having some issues. When I use this CMakeLists.txt ExternalProject_Add(host_mkfatfs PREFIX ${COMPONENT_PATH} SOURCE_DIR ${COMPONENT_PATH}/src CONFIGURE_COMMAND "" BUILD_IN_SOURCE 1 BUILD_COMMAND make INSTALL_COMMAND "" ) add_custom_target(mkfatfs ALL ...
by mishafarms
Sun Jul 28, 2019 4:28 am
Forum: ESP32 IDF
Topic: Problem installing IDF on linux
Replies: 6
Views: 1022

Re: Problem installing IDF on linux

I tried this all from scratch again. I had some minor issues I need to look at again with a fresh install. But everything seems to
be working now. I have a Raspberry pi 4 (4G) with an ESP32 development environment including eclipse.
Very Cool

Michael
by mishafarms
Wed Jul 24, 2019 12:40 pm
Forum: ESP32 IDF
Topic: Problem installing IDF on linux
Replies: 6
Views: 1022

Re: Problem installing IDF on linux

I am having this issue with a Raspberry pi 4 (still 32 bit I assume).
Any suggestions?

Michael
by mishafarms
Thu Sep 14, 2017 6:02 am
Forum: General Discussion
Topic: OpenOCD debug problem
Replies: 12
Views: 4245

Re: OpenOCD debug problem

Remove the gdbinit file and just run the debugger at the command line xtensa-esp32-elf-gdb. Then at the prompt type "target remote :3333" and you should see a message like Remote debugging using :3333 0x00000000 in ?? () in the gdb window and in the openocd you should see something like Info : accep...
by mishafarms
Tue Sep 12, 2017 11:56 am
Forum: General Discussion
Topic: sysview affects my program alot
Replies: 4
Views: 1698

Re: sysview affects my program alot

For the Segger I have 3Mhz for the WROVER it is 20Mhz. here is the output from the WROVER openocd -f ~/esp32.cfg Open On-Chip Debugger 0.10.0-dev-gb5ec731 (2017-07-20-09:41) Licensed under GNU GPL v2 For bug reports, read http://openocd.org/doc/doxygen/bugs.html none separate adapter speed: 20000 kH...
by mishafarms
Mon Sep 11, 2017 10:52 pm
Forum: General Discussion
Topic: sysview affects my program alot
Replies: 4
Views: 1698

sysview affects my program alot

I have a program running that I enabled sysview tracing (all freeRTOS events turned on). When I enable the sysview on the host side, all my timings are terrible. I have a timer firing every 550 us, in the timer interrupt I start a SPI transaction. The SPI completes and I handle it and setup for the ...

Go to advanced search