I cannot find any JTAG board configuration file for the kaluga-1 dev board.
Any chance that this might work?
Code: Select all
# Example OpenOCD configuration file for ESP32-KALUGA-1-KIT board. # # For example, OpenOCD can be started for ESP32 debugging on # # openocd -f board/esp32-kaluga-1-3.3v.cfg # # Source the JTAG interface configuration file source [find interface/ftdi/esp32_devkitj_v1.cfg] set ESP32_FLASH_VOLTAGE 3.3 # Source the ESP32S2 configuration file source [find target/esp32s2.cfg]
I also noted this: If psram was soldered, GPIO26 will be used
as CS, which can't be used as other functions. How do I know if the board (or module) comes with PSRAM?
Do esp-idf support this yet?
I will put the results of my experiments with the board here,