Changing the default UART pins

Palonso
Posts: 57
Joined: Tue Sep 24, 2019 8:43 pm

Changing the default UART pins

Postby Palonso » Thu May 28, 2020 5:32 pm

Hi,

I've seen in many places that you can change the UART pins to any other available pin with practically no restriction (apart from being output capability for TX), but I would like to know if there is any issue with the performance of it.

For example, I'm working with WROVER-B, is the same if I set the UART0 for GPIO1 and GPIO3 as for the GPIO27 and GPIO14?

Best regards,
P

WiFive
Posts: 2966
Joined: Tue Dec 01, 2015 7:35 am

Re: Changing the default UART pins

Postby WiFive » Fri May 29, 2020 1:23 am

You get an extra clock cycle of delay from the pins but uart is asynchronous anyway

Who is online

Users browsing this forum: Bing [Bot] and 9 guests