ESP32 Forum

Since the module has pins accessible from the outer perimeter of the module, I wonder if a module could be programmed in one device and used in a production app in another circuit. There are packaging requirements in production, and development boards provide interfaces which are often unnecessary in production. I'm not a mechanical engineer, but; it looks like the module could be pressure fit into metal compression pins in a plastic socket which would allow pry removal after programming.

If there's another technology which I'm obviously unaware of from my question, please don't hesitate to mention it.

Yes, I know the module can be un-soldered and re-soldered into another circuit, and that only a few pins are required for programming.

Thanks for any helpful comments.

lisanke wrote: Thanks for any helpful comments.

hi

you mean for the wroom32modul?

you click it, program it and remove it without soldering.

best wishes
rudi

thanks for the quick and helpful replies