Hi Espressif Community:
The ESP32-S3 datasheet describes the setup time and hold time timing for the strapping pins.
https://www.espressif.com/sites/default ... eet_en.pdf
2.6 Strapping Pins
Figure 2-4: Visualization of Timing Parameters for the Strapping Pins
tSU: Setup time is described as from VIH of Strapping pin to VIL_nRST of CHIP_PU.
Is this correct from VIH of Strapping pin to "VIH_nRST" of CHIP_PU?
I checked the signal waveforms of GPIO0 and CHIP_PU on ESP32-S3-DevkitC-1 when power is turned on,
The VIL_nRST of CHIP_PU from VIH of Strapping pin does not satisfy the condition of tSU,
The condition of tSU is satisfied by "VIH_nRST" from VIH to CHIP_PU of Strapping pin.
As for the Boot Mode of ESP32-S3-DevkitC-1, as described in Table 2-11, Chip Boot Mode Control,
it seems to operate normally with SPI Boot by identifying GPIO0 as 1.
Thanks,
N.N
Timing Parameters for the Strapping Pins
Who is online
Users browsing this forum: No registered users and 85 guests