Hi,
i am using a dev kit, ESP32-WRROM-32D, which i programm using VSCode + PlattformIO + espressif IDF. I can upload and run code just fine.
I am trying to change the USB PID/VID and serial number of my chip. I assume it its possible, i just dont know how its done. Any pointers?
changing usb VID/PID
-
- Posts: 9051
- Joined: Thu Nov 26, 2015 4:08 am
Re: changing usb VID/PID
An ESP32-WROOM-32D does not have an ESP with internal USB, so USB is provided by a (if memory serves) CP2102 chip. You should look into reprogramming that chip if you want to change its VID/PID.
Re: changing usb VID/PID
Thanks, i just took a close look at my esp board and yes there is a silabs CP2102 on there. I will have to check if and how i can reprogramm that one.
Re: changing usb VID/PID
Maybe stupid question, but why do you want to change VID/PID?
When you do it then most likely native drivers wont recognize device.
When you do it then most likely native drivers wont recognize device.
Who is online
Users browsing this forum: Bing [Bot], Ethapus and 245 guests