How to change UART2 TX Buffer limit?

ClosedLoop
Posts: 14
Joined: Mon May 16, 2022 8:13 am
Location: Portugal

How to change UART2 TX Buffer limit?

Postby ClosedLoop » Thu Aug 04, 2022 4:26 pm

Hello, I am using an ESP32 and a STM32 microcontroller in the same project. To communicate between the two i use UART2. I am trying to send structures between the two.I can receive from the STM fine but when i try to send a structure to the STM, i only receives 128 bytes. I don't know how i can change this limit. I would like to change it to 512.

Code: Select all

void init_uart2(){

	uart_debug.index=0;
	uart_debug.f_receive=0;

	//esp_log_level_set(TAGu2, ESP_LOG_INFO);
	/* Configure parameters of an UART driver,
	 * communication pins and install the driver */
    uart_config_t uart_config = {
        .baud_rate = 19200,
        .data_bits = UART_DATA_8_BITS,
        .parity = UART_PARITY_DISABLE,
        .stop_bits = UART_STOP_BITS_1,
        .flow_ctrl = UART_HW_FLOWCTRL_DISABLE
    };
    uart_param_config(UART_NUM_2, &uart_config);

    uart_set_pin(UART_NUM_2, PIN_TX_UART_2, PIN_RX_UART_2, UART_PIN_NO_CHANGE, UART_PIN_NO_CHANGE);

    uart_driver_install(UART_NUM_2, BUFFER_SIZE_UART2 * 2, 0,0,  NULL, 0);

    uart_isr_free(UART_NUM_2);

    uart_isr_register(UART_NUM_2,uart2_intr_handle, NULL, ESP_INTR_FLAG_IRAM, &handle_console);
    uart_enable_rx_intr(UART_NUM_2);



    myputsU0("\n \n Init Uart2 ok.\n");
}
I tried to change the tx_buffer_size in the driver install function to the same as the rx_buffer_size but everytime i send the structure the ESP reboots. I also tried to change some of the FIFO buffer sizes but to no avail.

Does anyone know how to change this limit?

Thank you.

Who is online

Users browsing this forum: Bing [Bot] and 148 guests