Suuuuuper simple circuit to wirelessly power an esp32-S2 dev kit with a supercapacitor

User avatar
lowtolerance
Posts: 9
Joined: Tue Dec 15, 2020 6:35 pm
Location: Virginia Beach, Virginia, United States of America

Suuuuuper simple circuit to wirelessly power an esp32-S2 dev kit with a supercapacitor

Postby lowtolerance » Wed Mar 17, 2021 4:51 pm

Supercapacitors have come a long way over the years, and recently some high capacity 3.8V supercapacitors have hit the market at very reasonable prices.

This is a 30F Eaton supercapacitor charged up to 3.3V powering an ESP32-S2 board completely — it can provide more than enough power for WiFi transmissions, with no power management or circuitry or code necessary! I was able to run the “restful_server” HTTP protocol example for a full 15 minutes!
B65CC094-9979-414B-80F8-A3279305FF0A.jpeg
B65CC094-9979-414B-80F8-A3279305FF0A.jpeg (3.06 MiB) Viewed 10842 times
I’m using one as a backup power supply to compensate for a puny LDO that can only output about 60mA, and it works like a charm!

ESP_Minatel
Posts: 361
Joined: Mon Jan 04, 2021 2:06 pm

Re: Suuuuuper simple circuit to wirelessly power an esp32-S2 dev kit with a supercapacitor

Postby ESP_Minatel » Thu Mar 18, 2021 3:24 pm

Hi,

That's really cool! Super caps are so cool! I did something similar with 2x Maxwell 3000F 2.7V ultra caps!

User avatar
lowtolerance
Posts: 9
Joined: Tue Dec 15, 2020 6:35 pm
Location: Virginia Beach, Virginia, United States of America

Re: Suuuuuper simple circuit to wirelessly power an esp32-S2 dev kit with a supercapacitor

Postby lowtolerance » Thu Mar 18, 2021 7:51 pm

3000F :lol:

3.8V supercapacitors are incredibly useful because you can charge them directly from a 3.3V power source, and discharge them at nearly 3.3V for a loooong time. Paired with an LDO with a very low voltage dropout such as the TLV75533, one could probably power an ESP32 in deep sleep indefinitely from a cheap 3V solar cell.

In practice, I’m using the supercapacitor to smooth current demands. The supercap has a low internal resistance from which I can siphon ~350mA worth of 3.3V power on demand without causing a big voltage drop on my primary 60mA power supply that would otherwise cause the ESP to reset. No additional circuitry is required, that’s just how supercapacitors work!

username
Posts: 477
Joined: Thu May 03, 2018 1:18 pm

Re: Suuuuuper simple circuit to wirelessly power an esp32-S2 dev kit with a supercapacitor

Postby username » Wed Mar 24, 2021 1:23 pm

3.8V supercapacitors are incredibly useful because you can charge them directly from a 3.3V power source
Technically yes. But you should not do that. A supercap that is low will act like a dead short to any power supply for a long time until it gets near a full charge. So if your using a PS that cannot handle a dead short for a long time you will smoke it.
There are IC designed for using super caps that should be used. They prevent this, and charge the cap with a configurable current setting.

Who is online

Users browsing this forum: No registered users and 39 guests