ENC28J60 ethernet module communication problem with ESP32

Posts: 1
Joined: Thu Jul 16, 2020 3:36 pm

ENC28J60 ethernet module communication problem with ESP32

Postby vardhan223 » Thu Jul 16, 2020 4:03 pm


I am new to this forum and ESP32 as well. Recently, I started working on ESP32. In my project, I connected the ENC28J60 module with ESP32 and other side of the ethernet shield is connected to TK800 router. I used ETHERCAD librarry to program the ESP32. The program is succesfully flashed into the ESP32.But, after that it is throwing some runtime error. The mesaage is shown below:

---------------------error message in serial monitor----------
rst:0xc (SW_CPU_RESET),boot:0x13 (SPI_FAST_FLASH_BOOT)
configsip: 0, SPIWP:0xee
mode:DIO, clock div:1
ho 0 tail 12 room 4
ho 0 tail 12 room 4
entry 0x400806b8
Trying to get an IP...
MAC: 74:69:69:2D:30:31
Failed to initialise EEPROM

-------------------ended here------------------------------------

Please explain me the issue and if you have another ethernet libraries, please share them.

Thank you in advance.
ESP_32 error with Bootloader.PNG
ESP_32 error with Bootloader.PNG (40.03 KiB) Viewed 400 times

Who is online

Users browsing this forum: No registered users and 19 guests