I2S in parallel mode

User avatar
Posts: 224
Joined: Tue Dec 05, 2017 8:28 pm
Location: Hungary

I2S in parallel mode

Postby Vader_Mester » Fri Jan 05, 2018 10:52 am

Hi All,

I could not find proper information in technical ref manual on how can I configure the data bus with in I2S ADC/DAC mode.
I have seen that in Figure 68, the DAC is shown with an 8bit wide bus, but not sure which registers should be set to achieve this.
Also I wish to know it is possible to use 8bit wide data in ADC mode as well, and is it necessary to pass the data to the ADC or can I use the data for anything else?

I'm asking, because I want to implement a HyperRAM using the I2S ADC/DAC modes.

Thanks & regrads,
There are 2 types of programmer people: The Expert programmer and The Smart programmer

The Expert programmer easily writes any code from scratch.
The Smart programmer uses his google/github powers first ;)

Return to “General Discussion”

Who is online

Users browsing this forum: gigijoe, Google [Bot], Nespressif and 30 guests