Hi,
i followed the procedure which you have given in the link
Steps followed....
step 1-----> cd ~/esp
step 2-----> git clone --recursive
https://github.com/espressif/openocd-esp32.git
step 3-----> sudo apt-get install make
sudo apt-get install libtool
sudo apt-get install pkg-config
sudo apt-get install autoconf
sudo apt-get install automake
sudo apt-get install texinfo
sudo apt-get install libusb-1.0
step 4-----> cd ~/esp/openocd-esp32
./bootstrap
./configure
make
step 5----->openocd -s . -f interface/jlink.cfg -f board/esp-wroom-32.cfg
this is what am getting
"Warn : Unexpected idcode after end of chain: 627 0x00000000
Error: double-check your JTAG setup (interface, speed, ...)
Error: Trying to use configured scan chain anyway...
Warn : AUTO auto0.tap - use "jtag newtap auto0 tap -irlen 2 -expected-id 0x00000000"
Error: auto0.tap: IR capture error; saw 0x0000 not 0x0001
Warn : Bypassing JTAG setup events due to errors
cpu0: Current bits set: none
cpu1: Current bits set: none"
Correct me if I am wrong and any suggestions on where I am going wrong is welcome.
let me know how to solve this.
thanks